Product: VCXO (Voltage Controlled Crystal Oscillators)
Output: LVCMOS Square Wave ; 50 MHz to 800 MHz
• "GF" series has the best performance with phase jitter < 1.0 ps. Output: LVCMOS Square Wave ; 50 MHz to 800 MHz
CMOS with frequency higher than 50 MHz and CMOS input
Download GV576 Specs. [
(139 KB) ]
Download GV576 Specs. [
(139 KB) ]• "GW" and "GV" use high-Q fundamental crystal and multiplier circuit.
• Both have moderate jitter. "GW" is up to 800 MHz. "GV" is up to 200 MHz with a lower cost.
General Specifications
Ta=+25°C, VDD= at specified voltage, CL=15 pF
| Product Series | " GF " series | " GW " series | " GV " series | |
|---|---|---|---|---|
| Technology | High Q fundamental crystal + ultra low jitter multiplier circuit | High Q fundamental crystal + low jitter multiplier circuit | High Q fundamental crystal + low jitter multiplier circuit | |
| Output Logic | LVCMOS | |||
| Frequency Range | 50.01 MHz ~ 200.0 MHz (15 pF load) | 50.01 MHz ~ 800.0 MHz | 50.01 MHz ~ 200.0 MHz | |
| 50.01 MHz ~ 320.0 MHz (10 pF load) | ||||
| Supply Voltage ( VDD ) | +3.3 VDD 5% | |||
| Supply Voltage Code | " 3 " | |||
| Output Voltage HIGH "1" |
90% of VDD min. | |||
| Output Voltage LOW "0" |
10% of VDD max. | |||
| Integrated Phase Jitter (12 KHz to 20 MHz) |
0.4 ps typ. (156.250 MHz) 0.5 ps max. |
2.6 ps typ. (155.520 MHz) 4 ps max. |
2.3 ps typ. (155.250 MHz) 4 ps max. |
|
| Period Jitter RMS |
3 ps typ. (156.250 MHz) 5 ps max. |
4.3 ps typ. (155.520 MHz) | 4.0 ps typ. (155.520 MHz) | |
| Period Jitter Peak-to-Peak |
20 ps typ. (156.250 MHz) 30 ps max. |
27 ps typ. (155.520 MHz) | 27 ps typ. (155.520 MHz) | |
| Phase Noise | Offset (Hz) | Frequency: 156.250 MHz | Frequency: 155.520 MHz | Frequency: 155.520 MHz |
| 10 Hz | -62 dBc / Hz | -65 dBc / Hz | -65 dBc / Hz | |
| 100 Hz | -92 dBc / Hz | -95 dBc / Hz | -95 dBc / Hz | |
| 1 KHz | -120 dBc / Hz | -120 dBc / Hz | -120 dBc / Hz | |
| 10 KHz | -132 dBc / Hz | -125 dBc / Hz | -128 dBc / Hz | |
| 100 KHz | -128 dBc / Hz | -121 dBc / Hz | -122 dBc / Hz | |
| 1 MHz | -140 dBc / Hz | -120 dBc / Hz | -120 dBc / Hz | |
| 10 MHz | -150 dBc / Hz | -140 dBc / Hz | -140 dBc / Hz | |
| Current Consumption (15 pF load) | < 100 MHz: 30 mA max. 100 MHz ~ 320 MHz: 40 mA max. |
< 96 MHz: 30 mA max. 96 MHz ~ 700 MHz: 40 mA max. |
25 mA max. | |
| Rise Time (Tr) / Fall Time (Tf) | 0.7 ns typical (0.3 V ↔ 3.0 V 15 pF Load) |
1.2 ns typical (0.3 V ↔ 3.0 V 15 pF Load) |
1.2 ns typical (0.3 V ↔ 3.0 V 15 pF Load) |
|
| Frequency Stability(1) Commercial temp. range (code "C") |
"A": ±25 ppm over 0°C to +70°C "B":±50 ppm over 0°C to +70°C "C":±100 ppm over 0°C to +70°C For non-standard please give desired frequency stability after the "C". For example "C20" is ±20 ppm over 0 to +70°C |
|||
| Frequency Stability(1) Industrial temp. range (code "I") |
"D":±25 ppm over -40°C to +85° (not available on all packages) "E":±50 ppm over -40°C to +85°C "F":±100 ppm over -40°C to +85°C For non-standard please give desired frequency stability after the "I". For example "I20" is ±20 ppm over -40 to +85°C |
|||
| Frequency Pulling Range | From ±50 ppm to ±120 ppm Control Voltage Range: +0.3 V to +3.0 V Control Voltage Center: +1.65 V |
|||
| Output Load | 15 pF | |||
| Start-up Time (Ts) | 10 m Sec. (max.) | |||
| Duty Cycle | 50% ± 5% (measured at 50% of VDD) | |||
| Linearity | 6% typical ; 10% max. | |||
| Modulation Bandwidth (at -3 dB) | 25 KHz min. 0V ≤ Vcontrol ≤ 3.3V | |||
| Input Impedance | 60 KΩ min. | 2 MΩ min. | 2 MΩ min. | |
| Slope Polarity (Transfer Function) | Monotonic and Positive: Increasing control voltage always increases output frequency. | |||
| Tri-state Control Characteristics | Tri-State enable high. No connection or 70% of VDD min. is applied to Tri-State pad to enable output. | |||
| 30% of VDD max. to disable output (high impedance) | ||||
| Aging | ±3 ppm per year first year ; ±2 ppm max. per subsequent year. | |||
| Packaging | 180 mm reel. 16mm tape. 1000 pcs. per reel. | |||
Product Summary:
| Output Wave Form: Square Wave | |||
|---|---|---|---|
|
Package Code |
Frequency Range |
Assembly Technique |
Package Description |
| Thru-Hole Types | |||
| GV14 | 12 MHz ~200 MHz | 4 pin DIL full size | 12.8 x 20.2 x 5.88H [0.504 x 0.795 x 0.231] |
| GV8 | 4 pin DIL half size |
12.8 x 12.8 x 5.88H [0.504 x 0.504 x 0.231] |
|
| GV39 | 4 pin DIL (low profile) | 11.7x 18.3 x 4.7H [0.461 x 0.720 x 0.185] |
|
| Gull Wing Surface Mount Types | |||
| GV24 | 12 MHz ~200 MHz | Gull wing version of G14 | 12.8 x 20.2 x 7.6H [0.504 x 0.795 x 0.300] |
| GV18 | Gull wing version of G8 | 12.8 x 12.8 x 7.6H [0.504 x 0.504 x 0.300] |
|
| GV47 | Gull wing version of G39 | 11.7x 21.3 x 4.7H [0.461 x 0.839 x 0.185] |
|
| Leadless Surface Mount Types | |||
| GV61 | 12 MHz ~200 MHz | 6 pad FR4 Leadless | 9.6 x 11.4 x 1.85H [0.378 x 0.449 x 0.073] |
| GV41 | 4 pad FR4 Leadless | 9.6 x 11.4 x 1.85H [0.378 x 0.449 x 0.073] |
|
| GV62 | 6 pad FR4 Leadless | 9.6 x 11.4 x 2.5H [0.378 x 0.449 x 0.098] |
|
| GV42 | 4 pad FR4 Leadless | 9.6 x 11.4 x 2.5H [0.378 x 0.449 x 0.098] |
|
| GV64 | 6 pad FR4 Leadless | 9.6 x 11.4 x 4.7H [0.378 x 0.449 x 0.185] |
|
| GV44 | 4 pad FR4 Leadless | 9.6 x 11.4 x 4.7H [0.378 x 0.449 x 0.185] |
|
| GV534 | 12 MHz ~200 MHz | 4 pad Ceramic Leadless | 5.0 x 3.2 x 1.2H [0.197 x 0.275 x 0.067] |
| GV576 | 12 MHz ~200 MHz | 6 pad Ceramic Leadless | 5.0 x 7.0 x 1.7H [0.197 x 0.275 x 0.067] |
| GV575 | 12 MHz ~200 MHz | 6 pad Leadless | 5.0 x 7.5 x 2.65H [0.197 x 0.295 x 0.104] |